4 tiny screens in advcfg?

(I apologize for cross posting from the forum, but I haven't seen any 
results on the forum).

I'm trying to get Advmenu and Advmame going on my standard arcade 
monitor (as everyone is probably painfully aware at this point). I 
previously had this all set up with 0.72 on a Cirrus Logic card and 
FreeDOS. That setup worked well but I wanted something that could run 
more games, so I built a new machine. Same cabinet with new hardware 
(Radeon 9250) running linux framebuffer. In both cases, I'm using a JPac. 
 
When I run advcfg and enter the information for a standard arcade 
monitor, following the steps on the EasyMameCab I can't seem to get a 
mode that actually works. It starts out as garbage in the middle of the 
screen. If I press Shift-i 11 times I will consistently get a screen 
with 4 tiny copies of the advcfg screen in each corner. That's it. That 
is the best I can do. 
 
Am I doing something wrong? Is there something wrong with using this 
video card or is there something wrong with the monitor? 
 
Please help before I pull the small amount of remaining hair out. 
 
Thanks, 
Craig


-------------------------------------------------------
SF email is sponsored by - The IT Product Guide
Read honest & candid reviews on hundreds of IT Products from real users.
Discover which products truly live up to the hype. Start reading now.
http://ads.osdn.com/?ad_id=6595&alloc_id=14396&op=click
___
Unsubscribe at https://lists.sourceforge.net/lists/listinfo/advancemame-users