secureplt support
Douglas Coup <[email protected]>
| Newsgroups | gmane.comp.gcc.cross-compiling |
|---|---|
| Message-ID | <[email protected]> |
Hi. A potential customer has pointed out that the tool chain they use shows this when they enter "gcc -v": Configured with: ...--enable-secureplt... In other words one of the items their tool chain is configured with is the --enable-secureplt setting. Is it possible to enable this setting in a tool chain produced by Crosstool-NG? I couldn't find an obvious configuration item for this in the menus shown by the "ct-ng menuconfig" command. The tool chain needs to target 32-bit PowerPC. Regards, Douglas Coup -- Objective Systems, Inc. REAL WORLD ASN.1 AND XML SOLUTIONS Tel: +1 (484) 875-9841 Fax: +1 (484) 875-9830 Toll-free: (877) 307-6855 (USA only) http://www.obj-sys.com