RE: secureplt support

<[email protected]> Fri, 23 Mar 2018 10:03:11 -0700

Newsgroups	gmane.comp.gcc.cross-compiling
Message-ID	<[email protected]>

Douglas,

> -----Original Message-----
> From: [email protected] <[email protected]>
> On Behalf Of Douglas Coup
> Sent: Friday, March 23, 2018 9:01 AM
> To: [email protected]
> Subject: secureplt support
> 
> Hi.
> 
> A potential customer has pointed out that the tool chain they use shows this
> when they enter "gcc -v":
> 
> Configured with:  ...--enable-secureplt...
> 
> In other words one of the items their tool chain is configured with is the --
> enable-secureplt setting.  Is it possible to enable this setting in a tool chain
> produced by Crosstool-NG?  I couldn't find an obvious configuration item for
> this in the menus shown by the "ct-ng menuconfig"
> command.  The tool chain needs to target 32-bit PowerPC.

Yes, actually you can add '--enable-secureplt...' to an option under: 'C compiler -> gcc extra config'.
In the .config file this option is: CT_CC_GCC_EXTRA_CONFIG_ARRAY

> Regards,
> 
> Douglas Coup

Cheers,

-Bryan

> --
> Objective Systems, Inc.
> REAL WORLD ASN.1 AND XML SOLUTIONS
> Tel: +1 (484) 875-9841
> Fax: +1 (484) 875-9830
> Toll-free: (877) 307-6855 (USA only)
> http://www.obj-sys.com

signature.asc (application/pgp-signature, 834 B)