(unknown)

Hi Kundu,

Try using the same JX (x and y scales) in the pscoast and psxyz commands,
it works for me.
HTH,

by the way,
I try your commands and seems that -K in the psxyz command "close"
the ps files, in the sense i can open the ps file,
i use the version psxyz 4.5.10_r10040 [64-bit] on OSX.

Cheers

Milton
**********************************
Milton P. PLASENCIA LINARES

Dipartimento Centro di Ricerche Sismologiche
Istituto Nazionale di Oceanografia e di Geofisica Sperimentale - OGS

Borgo Grotta Gigante 42/C
(34010) Sgonico - TRIESTE - ITALIA
Tel: +39-040-2140 256/141
Fax: +39-040-327307

E-mail: [email protected]

ASAIN (Antarctic Seismographic Argentinean Italian Network)
*********************************


Quoting "Kundu, Shuvashish" <[email protected]>:

> Hello,
>
> I am using the following code to get the attached figure.
>
> pscoast -R130/210/10/70 -JX7.5id/5.5id -Di -Gwhite -N1/obese -Wblack  
>  -Swhite -E160/40 -K -X1i -Y1.5i>diacid.ps
> psxyz diacid.dat -R130/210/10/70/0/200 -JX7id/5id -JZ3i -So0.05i   
> -W0.2p -O -K -E160/40 -Gred -X0 -Y0 -Z0   
> -B10g10/10g10/a50:"Concentration (ng m@+-3@+)":wSnEZ>>diacid.ps
>
> In the figure, map goes out of the boundary. Can anyone help me to   
> solve this issue?
>
> Thank you,
>
> Kundu
>
> To unsubscribe, send the message "signoff gmt-help" to   
> [email protected]
>


----------------------------------------------------------------
This message was sent using IMP, the Internet Messaging Program.

To unsubscribe, send the message "signoff gmt-help" to [email protected]