Re: newbie question about mapproject

Sorry... I've been out of the office for a while.  I think it may be a bit 
of "over ambition" on my part.   I'm using a *MUCH* larger dataset in my 
implementation that the original author did.  Let me try a smaller dataset 
before I start complaining too loudly, and then have to eat crow.

Bruce

On Wed, 23 Apr 2014 08:50:05 -1000, Paul Wessel wrote:

> Hi Bruce-
> 
> Could you make a small portion that demonstrates the fail (or otherwise
> the entire file) of your input file available so I can debug?
> -p
> 
> On Apr 23, 2014, at 2:29 AM, Bruce Bowler <[email protected]> wrote:
> 
>> I have some code written by someone else that uses 4.something.  I have
>> 5.1.1 on my machine.
>> 
>> One of the commands that was in the original was
>> 
>> mapproject -R-124/-116.5/31.25/38 -JQ-120.25/14.4 -bis3 -bos3 -S  -V
>> 
>> (as part of a pipe stream)
>> 
>> I've changed that to
>> 
>> mapproject -R-71/-65/41/45 -JQ-68/43.5 -bi3f -bo3f -S  -V < ptemp >
>> mtemp
>> 
>> and taken the pipe out of the picture by having the previous command
>> output to ptemp.
>> 
>> The problem is that command will run for hours, so clearly I need to do
>> something else, but I'm not sure what.
>> 
>> Any hints most graciously accepted...
>> 
>> Bruce

To unsubscribe, send the message "signoff gmt-help" to [email protected]