Re: newbie question about mapproject

Let's just say "Garbage in, curious results"

When I don't append a PNG file to the input file (overly broad use of 
wildcards) things work as expected (more or less).

Bruce

On Thu, 24 Apr 2014 14:45:53 +0000, Bruce Bowler wrote:

> Sorry... I've been out of the office for a while.  I think it may be a
> bit of "over ambition" on my part.   I'm using a *MUCH* larger dataset
> in my implementation that the original author did.  Let me try a smaller
> dataset before I start complaining too loudly, and then have to eat
> crow.
> 
> Bruce
> 
> On Wed, 23 Apr 2014 08:50:05 -1000, Paul Wessel wrote:
> 
>> Hi Bruce-
>> 
>> Could you make a small portion that demonstrates the fail (or otherwise
>> the entire file) of your input file available so I can debug?
>> -p
>> 
>> On Apr 23, 2014, at 2:29 AM, Bruce Bowler <[email protected]> wrote:
>> 
>>> I have some code written by someone else that uses 4.something.  I
>>> have 5.1.1 on my machine.
>>> 
>>> One of the commands that was in the original was
>>> 
>>> mapproject -R-124/-116.5/31.25/38 -JQ-120.25/14.4 -bis3 -bos3 -S  -V
>>> 
>>> (as part of a pipe stream)
>>> 
>>> I've changed that to
>>> 
>>> mapproject -R-71/-65/41/45 -JQ-68/43.5 -bi3f -bo3f -S  -V < ptemp >
>>> mtemp
>>> 
>>> and taken the pipe out of the picture by having the previous command
>>> output to ptemp.
>>> 
>>> The problem is that command will run for hours, so clearly I need to
>>> do something else, but I'm not sure what.
>>> 
>>> Any hints most graciously accepted...
>>> 
>>> Bruce
> 
> To unsubscribe, send the message "signoff gmt-help" to
> [email protected]

To unsubscribe, send the message "signoff gmt-help" to [email protected]