re: bubblemon Gnome 2 compiles/installs but can't start

Mike N <mike-kill-a-spammer-for-the-buddha-n-b6nU5NY6NWS37wzq7ap9IgC/[email protected]> Thu, 21 Nov 2002 16:53:56 -0800

Newsgroups	gmane.comp.gnome.apps.bubblemon
Message-ID	<[email protected]>

looks like the files get put in different places if you build via the
.gz file and run "./configure ; make ; make install".  bubblemon-gnome2
ends up in /usr/local/bin, but the spec file says it should go into /usr/bin.

i downloaded bubblemon-2.0.0-2.src.rpm, ran "rpmbuild --recompile" on it,
installed the resulting bubblemon-2.0.0-2.i386.rpm using "rpm -i", ran
"killall -HUP gnome-panel", and was then able to find/start it under
Add To Panel -> Utility, and it works just fine.