Re: re: bubblemon Gnome 2 compiles/installs but can't start

Hi, sorry for the delayed reply. Glad to know it's working.

About the tar.gz problem, did you have run the configure with the 
--prefix=/usr option? 
You can find this installation instructions in the INSTALL doc, but
basically the bubblemon installation instructions are the same as any
tar.gz package:

cd to the untarred bubblemon directory
./configure --prefix=/usr
make 
make install (as root)

If you don't specify the prefix, /usr/local is used as default.

Cheers,

Juan


On Thu, 2002-11-21 at 21:53, Mike N wrote:
> looks like the files get put in different places if you build via the
> .gz file and run "./configure ; make ; make install".  bubblemon-gnome2
> ends up in /usr/local/bin, but the spec file says it should go into /usr/bin.
> 
> i downloaded bubblemon-2.0.0-2.src.rpm, ran "rpmbuild --recompile" on it,
> installed the resulting bubblemon-2.0.0-2.i386.rpm using "rpm -i", ran
> "killall -HUP gnome-panel", and was then able to find/start it under
> Add To Panel -> Utility, and it works just fine.
> 
> 
> 
> _______________________________________________
> Bubblemon-list mailing list
> [email protected]
> http://mail.nongnu.org/mailman/listinfo/bubblemon-list
>