Re: Issues with gkrellm-uguru and gkrellm-hddtemp
Steven Collins <[email protected]>
| Newsgroups | gmane.comp.gnome.apps.gkrellm |
|---|---|
| Message-ID | <[email protected]> |
At 11:56 PM 8/2/2006, you wrote: >You don't need a plugin for hddtemp. If the hddtemp daemon is running when >gkrellm starts, you should find hddtemp/xxx temperatures you can enable in >the Builtins->Sensors->Setup config page. And I do need to remove the hddtemp >link from the plugins page. > >Bill Bill, Sweet. I hadn't configured hddtemps.conf previously, so the builtin hddtemp support wasn't showing up. I just found and configured the configuration file earlier this evening, so when I went back and checked just a moment ago, the drives were indeed showing up in the sensors. Turned them on and life is good! No display problems like the plugin. Thanks for the info. Now if I can just get those zero readings gone... :-D Regards, Steven _______________________________________________ Gkrellm mailing list [email protected] http://lists.jutley.org/cgi-bin/mailman/listinfo/gkrellm