Re: support for fans in nvidia gtx285?
Bill Wilson <[email protected]>
| Newsgroups | gmane.comp.gnome.apps.gkrellm |
|---|---|
| Message-ID | <[email protected]> |
On Tue, 28 Jul 2009 21:09:12 -0400 Rio <[email protected]> wrote: > ok i did it twice once with the adt7473 kernel module loaded and got 2 > different readouts. > > first, this is with the 7473 module loaded: > > --- GKrellM 2.3.2 --- > hddtemp_daemon_read (once a minute): > |/dev/sda|WDC WD7502ABYS-02A6B0|34|C||/dev/sdb|WDC WD7502ABYS-02A6B0| > 33|C| > nvidia-settings gpus = 2 > libsensors: init OK > it8718:/sys/devices/platform/it87.656 it8718@290/in0 290ffff > it8718:/sys/devices/platform/it87.656 it8718@290/in1 290ffff The "libsensors init OK" line says that lm_sensors is being used and it has apparently detected an it8718 chip. > then this is without the module loaded: > > hddtemp_daemon_read (once a minute): > |/dev/sda|WDC WD7502ABYS-02A6B0|34|C||/dev/sdb|WDC WD7502ABYS-02A6B0| > 33|C| > nvidia-settings gpus = 2 > libsensors: init OK > it8718:/sys/devices/platform/it87.656 it8718@290/in0 290ffff > it8718:/sys/devices/platform/it87.656 it8718@290/in1 290ffff And again lm_sensors initializes to an it8718 chip independent of whether you have the 7473 module loaded. Do you also have a it8718 module loaded? Look in the directory /sys/devices/platform and see if there are directories for the 7473 and it8718. Well, it seems you will have the 8718 directory, but I don't know why if you have a different chip. If you do have the 7473 directory also, you could try running: gkrellm -d 0x80 --without-libsensors and see what gkrellm tries to do :) > fans 1-4 are for the motherboard and work fine. fan5 duplicates fan4. > none of the it87 inX voltages are correct except in1 which is the ram voltage. > all the others are useless. eg: i read somewhere in3 was supposed to be the 5v > line. it reads 2.94v > > but anyway i don't see anything with or without the 7473 loaded to help. If neither lm_sensors or gkrellm knows about the adt7473 chip, voltage factors will most likely be wrong and you will probably need to track down what the scaling factors need to be for the various inX voltages. To be able to adjust the scaling factors you will need to be running gkrellm -without-libsensors because gkrellm expects that when lm_sensors is being used, it knows what it is doing and will have scaled everything correctly. Bill ______________________________________________ Gkrellm mailing list [email protected] Read archives-join-leave-set RSS feed: http://archive.lists.netservicesgroup.com This service is provided by The Network Services Group: http://www.netservicesgroup.com