Re: gkrellm only shows temp from one gpu
Bill Wilson <[email protected]> Mon, 6 Jun 2011 08:30:37 -0500
| Newsgroups | gmane.comp.gnome.apps.gkrellm |
|---|---|
| Message-ID | <[email protected]> |
On Mon, 6 Jun 2011 00:32:36 -0400 Philipp Bliedung <[email protected]> wrote: > compiled the source and ran gkrellm but the nvidia-smi sensor option did not show up under Setup -> Senors. > > Do I have to set a certain compiler flag? > I just ran make and make install without any flags. I looked back over your emails and now see that the output you posted from your nvidia-smi command is formatted differently from the output I get. If you will hang on for a bit, I'll update gkrellm to handle this and post a new tarball for you to try. Bill ______________________________________________ Gkrellm mailing list [email protected] Read archives-join-leave-set RSS feed: http://archive.lists.netservicesgroup.com This service is provided by The Network Services Group: http://www.netservicesgroup.com