Re: gkrellm only shows temp from one gpu

On Mon, 6 Jun 2011 00:32:36 -0400
Philipp Bliedung <[email protected]> wrote:

>>  compiled the source and ran gkrellm but the nvidia-smi sensor option did not show up under Setup -> Senors.
>> 
>> Do I have to set a certain compiler flag?
>> I just ran make and make install without any flags.
>
>I looked back over your emails and now see that the output you posted from
>your nvidia-smi command is formatted differently from the output I get.
>
>If you will hang on for a bit, I'll update gkrellm to handle this and post
>a new tarball for you to try.

I've replaced the tarball with one you can try, same URL:

	http://members.dslextreme.com/users/billw/test/gkrellm-test.tar.bz2

Just make and install as you did before, no special flags needed.  If it
doesn't work as expected, post the output you get from:  gkrellm -d 0x80.

Anybody running the previous test tarball to get nvidia-smi temps will have
to re-enable your nvidia-smi temps in the config with this new tarball or
when 2.3.6 is released.

Bill

______________________________________________
Gkrellm mailing list
[email protected]
Read archives-join-leave-set RSS feed:
http://archive.lists.netservicesgroup.com
This service is provided by The Network Services Group:
http://www.netservicesgroup.com