Re: gkrellm only shows temp from one gpu

On Mon, Jun 6, 2011 at 9:08 PM, Bill Wilson <[email protected]> wrote:

> On Mon, 6 Jun 2011 00:32:36 -0400
> Philipp Bliedung <[email protected]> wrote:
>
> >>  compiled the source and ran gkrellm but the nvidia-smi sensor option
> did not show up under Setup -> Senors.
> >>
> >> Do I have to set a certain compiler flag?
> >> I just ran make and make install without any flags.
> >
> >I looked back over your emails and now see that the output you posted from
> >your nvidia-smi command is formatted differently from the output I get.
> >
> >If you will hang on for a bit, I'll update gkrellm to handle this and post
> >a new tarball for you to try.
>
> I've replaced the tarball with one you can try, same URL:
>
>        http://members.dslextreme.com/users/billw/test/gkrellm-test.tar.bz2
>
> Just make and install as you did before, no special flags needed.  If it
> doesn't work as expected, post the output you get from:  gkrellm -d 0x80.
>
> Anybody running the previous test tarball to get nvidia-smi temps will have
> to re-enable your nvidia-smi temps in the config with this new tarball or
> when 2.3.6 is released.
>
>
Bill, thanks for the quick update!
the updated tarball works great. both nvidia-smi sensors show up in the
Setup and temps for both cards are displayed properly.



> Bill
>
> ______________________________________________
> Gkrellm mailing list
> [email protected]
> Read archives-join-leave-set RSS feed:
> http://archive.lists.netservicesgroup.com
> This service is provided by The Network Services Group:
> http://www.netservicesgroup.com
>
>