Re: z22 not syncing anymore

----- Original Message -----
From: Adam C Powell IV
Time: 12-09-07 19:08
> On Tue, 2007-09-11 at 22:30 +0200, Tom Billiet wrote: 
>   
>> I'm using archlinux, which has a "rolling release" system. That means
>> that it has always the latest packages in the current repository. This
>> also means that I can't answer to this question, I get continuous
>> upgrades... It can be a kernel upgrade, it can be something else...
>>     
>
> Okay, then what versions of the kernel, pilot-link, gnome-pilot?
>   
Gnome-pilot: 2.0.15
pilot-link: 0.12.2
Kernel: 2.6.22.6
>  
>   
>
> Sorry to hear that.
>
> Just to verify: before and after trying libusb, you did "lsmod" and it
> did not include visor?
>   
Yeah, blacklisted it on every possible way I could find and checked it
every way I could imagine, no more traces found.
> -Adam
>   
But as David A. Desrosiers says in another thread, it might be better to
get first the visor module back to work before beginning with libusb.
The fact that the visor module isn't working anymore has something to do
with a kernel/udev change I think.

This is what it used to be:
When I connected the palm, ttyUSB0 and ttyUSB1 were created, and at the
moment I hit the hotsync button ttyUSB3 and ttyUSB4 are created, and (I
think) ttyUSB0 and ttyUSB1 will disappear shortly thereafter.


This is what it is now: (output from dmesg)
usb 1-1: new full speed USB device using ohci_hcd and address 26
usb 1-1: configuration #1 chosen from 1 choice
visor 1-1:1.0: Handspring Visor / Palm OS converter detected
usb 1-1: Handspring Visor / Palm OS converter now attached to ttyUSB0
usb 1-1: Handspring Visor / Palm OS converter now attached to ttyUSB1

-> now I press the hotsync button

usb 1-1: USB disconnect, address 26
visor ttyUSB0: Handspring Visor / Palm OS converter now disconnected
from ttyUSB0
visor ttyUSB1: Handspring Visor / Palm OS converter now disconnected
from ttyUSB1
visor 1-1:1.0: device disconnected
usb 1-1: new full speed USB device using ohci_hcd and address 27
usb 1-1: device descriptor read/all, error -62
usb 1-1: new full speed USB device using ohci_hcd and address 28
usb 1-1: configuration #1 chosen from 1 choice
visor 1-1:1.0: Handspring Visor / Palm OS converter detected
usb 1-1: Handspring Visor / Palm OS converter now attached to ttyUSB0
usb 1-1: Handspring Visor / Palm OS converter now attached to ttyUSB1

And at this point it is not responding anymore and will timeout...
Does anybody knows this problem?

Thank,
Tom

_______________________________________________
gnome-pilot-list mailing list
[email protected]
http://mail.gnome.org/mailman/listinfo/gnome-pilot-list