Re: palm usb_device doesn't seem to disconnect
"Dan Nicholson" <[email protected]>
| Newsgroups | gmane.comp.freedesktop.hal,gmane.comp.gnome.apps.pilot |
|---|---|
| Message-ID | <[email protected]> |
On 10/11/07, Bastien Nocera <[email protected]> wrote: > On Thu, 2007-10-11 at 11:08 +0100, Matt Davey wrote: > > On Thu, 2007-10-11 at 10:27 +0100, Bastien Nocera wrote: > <snip> > > > I'm not sure this is relevant, but most of my problems with device nodes > > > not going away were fixed with a newer udev (at the time). > > > > > > That was my bug report: > > > https://bugzilla.redhat.com/show_bug.cgi?id=203932 > > > > Hmm. As far as I remember, when I reproduced this issue the device > > nodes did indeed disappear, including the /proc/bus/usb/ entries. It > > was just the lshal entry that hung around. I can check this evening (12 > > hours). > > Then it would be a hal issue indeed. Could you reproduce when hal is > running with "hald --daemon=no --verbose=yes"? The other thing that would help is to run `udevmonitor' while plugging/unplugging. If no events are being received by udev, then the problem's either with udev or in the kernel. -- Dan