Re: palm usb_device doesn't seem to disconnect

Hi again,

On Thu, 2007-10-11 at 06:05 -0700, Dan Nicholson wrote:
> On 10/11/07, Bastien Nocera <[email protected]> wrote:
> > On Thu, 2007-10-11 at 11:08 +0100, Matt Davey wrote:
> > > On Thu, 2007-10-11 at 10:27 +0100, Bastien Nocera wrote:
> > <snip>
> > > > I'm not sure this is relevant, but most of my problems with device nodes
> > > > not going away were fixed with a newer udev (at the time).
> > > >
> > > > That was my bug report:
> > > > https://bugzilla.redhat.com/show_bug.cgi?id=203932
> > >
> > > Hmm.  As far as I remember, when I reproduced this issue the device
> > > nodes did indeed disappear, including the /proc/bus/usb/ entries.  It
> > > was just the lshal entry that hung around.  I can check this evening (12
> > > hours).
> >
> > Then it would be a hal issue indeed. Could you reproduce when hal is
> > running with "hald --daemon=no --verbose=yes"?
> 
> The other thing that would help is to run `udevmonitor' while
> plugging/unplugging. If no events are being received by udev, then the
> problem's either with udev or in the kernel.

I'm attaching a haldaemon and udevmonitor logs from both the first and
second sync.  The first sync was successful, the second was not detected
by gnome-pilot.

For what it's worth, I find that I can sync once per hald restart.  I
don't have to reboot, I just need to restart hald.

Hope this helps,

Matt

Matt Davey		Did you hear about the new corduroy pillow?
[email protected] 		It's making headlines all over town.