[bug #66796] contour producing numerous small lines for single contour

krisk <[email protected]> Fri, 29 May 2026 16:00:59 -0400 (EDT)

Newsgroups	gmane.comp.gnu.octave.bugs
Message-ID	<[email protected]>

Please use the bug tracker to post updates to a bug report.  The mailing list is intended as a read-only notification stream.  Info posted to this mailing list address won't appear in the tracker database where it is most useful.

Follow-up Comment #5, bug #66796 (group octave):

Hello Dmitri, thank you for the solution. In my case I was re-plotting the
returned contours, and the height/segment count columns were disrupting that
plot. I just had to cull any values over such a limit, as the height was much
greater than the X/Y coordinates. 

Thank you again for the solution, I do appreciate it. I hope my report may
help shine a light on the situation for anyone else encountering this.

Regards,
Kris


    _______________________________________________________

Reply to this item at:

  <https://savannah.gnu.org/bugs/?66796>

_______________________________________________
Message sent via Savannah
https://savannah.gnu.org/

signature.asc (application/pgp-signature, 228 B)