Re: Connecting lines to lines.

Your description isn't entirely clear, but you need to do three things to
get what I think you want:

1. Make sure that the bus line has ³Allow connections from lines² checked in
the Properties: Connections inspector
2. Choose the Orthogonal line type for the lines from the bus to the system
objects (Style: Lines and Shapes inspector)
3. Wayne Brissette has already mentioned setting the line hop style in the
Style: Lines and Shapes inspector

- John

On 6/2/10 1:40 PM, "Michael Tiernan" <[email protected]> wrote:

> I *know* I'm looking right at the solution to this but I can't find it.
> 
> I'm attempting to make a network diagram.
> 
> I have one line, the buss, going vertically (not that the direction
> matters here), and smaller lines of the same make up that are going
> horizontally between that buss and the systems.
> 
> I'd like to make nice clean right angled connections so that when I
> cross the two networks, they hop-over each other but the parts of one
> network are attached and if I move something, the connection goes with it.
> 
> Can anyone give me a pointer into the help docs for where I've got to
> read to learn this?
> 
> Thank you for everyone's time.
>