Re: printing from command line does not work

hi emile

On Wed, 2004-01-14 at 07:43, Emile Snyder wrote:
> I'm mostly just a lurker here, but I got curious after your email, and
> went digging around in the source.  The print-to-a-file function
> contents is #ifdef'ed out.  

I found the section in print.c - it seems to me however, that the
ifdef'ed out code differs substiantially from the sp_print_document()
function - it could be that it's rather old code.

> I mucked around and managed to get the
> printing to work by calling

did it print to a file and just throw a warning or did it just die when
running?

thanks for your time & help!

regards
nicola

-- 
mediagonal sa // route de la fonderie 7 // ch-1700 fribourg
tel 026 422 25 11 // key id 0x795D5392 // www.mediagonal.ch



-------------------------------------------------------
This SF.net email is sponsored by: Perforce Software.
Perforce is the Fast Software Configuration Management System offering
advanced branching capabilities and atomic changes on 50+ platforms.
Free Eval! http://www.perforce.com/perforce/loadprog.html