Re: printing from command line does not work

On Wed, 2004-01-14 at 00:05, Nicola Fankhauser wrote:
> hi emile
> 
> On Wed, 2004-01-14 at 07:43, Emile Snyder wrote:
> > I'm mostly just a lurker here, but I got curious after your email, and
> > went digging around in the source.  The print-to-a-file function
> > contents is #ifdef'ed out.  
> 
> I found the section in print.c - it seems to me however, that the
> ifdef'ed out code differs substiantially from the sp_print_document()
> function - it could be that it's rather old code.

Yes, that's what I assumed.  The changes I mentioned were to get the new
printing stuff to go to a file, rather than changes to re-enable the old
code block.

> > I mucked around and managed to get the
> > printing to work by calling
> 
> did it print to a file and just throw a warning or did it just die when
> running?

Yes, printed to the file.  Ugly ugly changes though :)

later,
-emile

> thanks for your time & help!
> 
> regards
> nicola
+----------------------------------------------------------------- "The
Two Phases Of University Employment: 1. Doesn't know enough to get a
Real Job. 2. Knows too much to want a Real Job." -- sharks
+-----------------------------------------------------------------



-------------------------------------------------------
This SF.net email is sponsored by: Perforce Software.
Perforce is the Fast Software Configuration Management System offering
advanced branching capabilities and atomic changes on 50+ platforms.
Free Eval! http://www.perforce.com/perforce/loadprog.html