Re: NR70V/E

On Thu, May 01, 2003 at 06:36:13PM +0000, Joe Foy wrote:
> This is what I get when I press the hotsync button
> Vigor14 kernel: hub.c: USB new device connect on bus1/2, assigned device 
> number 4
> Vigor14 kernel: usbserial.c: Sony Clié 4.x converter detected
> Vigor14 kernel: visor.c: Sony Clié 4.x: Number of ports: 2
> Vigor14 kernel: visor.c: Sony Clié 4.x: port 1, is for Generic use and is bound to ttyUSB0
> Vigor14 kernel: visor.c: Sony Clié 4.x: port 2, is for HotSync use and is bound to ttyUSB1
> Vigor14 kernel: usbserial.c: Sony Clié 4.x converter now attached to ttyUSB0 (or usb/tts/0 for devfs)
> Vigor14 kernel: usbserial.c: Sony Clié 4.x converter now attached to ttyUSB1 (or usb/tts/1 for devfs)

Good, your kernel driver is working properly.

Now do you have the latest version of pilot-link from pilot-link.org?

thanks,

greg k-h

_______________________________________________
clie-linux mailing list
[email protected]
http://kreucher.net/mailman/listinfo/clie-linux

Sony Clié and Linux Homepage:
http://kreucher.net/clie/