Re: Help with Sony Clie PEG-SJ33/E
Neil <[email protected]> Sat, 3 May 2003 02:07:18 -0700 (PDT)
| Newsgroups | gmane.comp.handhelds.clie.linux |
|---|---|
| Message-ID | <[email protected]> |
weird, i never got that problem. I also have the clie sj-33 and i'm using it fine with jpilot and pilot-xfer. i'm using kernel 2.4.20 as well. have you checked to make sure you have everything needed in the kernel? Neil --- james mears <[email protected]> wrote: > Hi. I am new to this list. > > I hope you can help me. I have a Sony Clie > PEG-SJ33/E and I am getting > the following weird kernel messages when I press the > hotsync button on the > Clie. (below) > > I cannot get pilot-link to work but I can mount the > memory stick as > /dev/sdb1 > > I am running SuSE 8.2 with kernel 2.4.20 and the > USB cable that came with the Clie and not a cradle. > (do I need a cradle?) > > I have /dev/pilot setup to /dev/ttyUSB1 also tried > it linked to /dev/ttyUSB0 > and have read/write permissions on both. My old > Handspring Visor works fine > so I know it is not a problem with the general > setup. > > Any help would be great. > > Thanks > > James > > > May 1 18:55:35 baldrick kernel: hub.c: new USB > device 00:1f.4-2, > assigned address 18 > May 1 18:55:35 baldrick kernel: usbserial.c: > Handspring Visor / Palm 4.0 > / Clié 4.x converter detected > May 1 18:55:35 baldrick kernel: visor.c: Handspring > Visor / Palm 4.0 / > Clié 4.x: Number of ports: 2 > May 1 18:55:35 baldrick kernel: visor.c: Handspring > Visor / Palm 4.0 / > Clié 4.x: port 1, is for Generic use and is bound to > ttyUSB0 > May 1 18:55:35 baldrick kernel: visor.c: Handspring > Visor / Palm 4.0 / > Clié 4.x: port 2, is for HotSync use and is bound to > ttyUSB1 > May 1 18:55:35 baldrick kernel: usbserial.c: > Handspring Visor / Palm 4.0 > / Clié 4.x converter now attached to ttyUSB0 (or > usb/tts/0 for devfs) May > 1 18:55:35 baldrick kernel: usbserial.c: Handspring > Visor / Palm 4.0 / > Clié 4.x converter now attached to ttyUSB1 (or > usb/tts/1 for devfs) May > 1 18:55:39 baldrick kernel: Device not ready. Make > sure there is a disc > in the drive. > May 1 18:55:39 baldrick kernel: sda : READ CAPACITY > failed. > May 1 18:55:39 baldrick kernel: sda : status = 1, > message = 00, host = > 0, driver = 08 > May 1 18:55:39 baldrick kernel: Info fld=0xa00 > (nonstd), Current > sd00:00: sns = 70 2 > May 1 18:55:39 baldrick kernel: Raw sense data:0x70 > 0x00 0x02 0x00 0x00 > 0x0a 0x00 0x00 > May 1 18:55:39 baldrick kernel: sda : block size > assumed to be 512 > bytes, disk size 1GB. > May 1 18:55:39 baldrick kernel: sda: I/O error: > dev 08:00, sector 0 > May 1 18:55:39 baldrick kernel: lost async page > write due to I/O error > on 08:00 > May 1 18:55:39 baldrick last message repeated 7 > times > May 1 18:55:39 baldrick kernel: I/O error: dev > 08:00, sector 0 > May 1 18:55:39 baldrick kernel: lost async page > write due to I/O error > on 08:00 > May 1 18:55:39 baldrick last message repeated 7 > times > May 1 18:55:39 baldrick kernel: I/O error: dev > 08:00, sector 2097144 > May 1 18:55:39 baldrick kernel: lost async page > write due to I/O error > on 08:00 > May 1 18:55:39 baldrick last message repeated 5 > times > May 1 18:55:39 baldrick kernel: I/O error: dev > 08:00, sector 2097144 > May 1 18:55:39 baldrick kernel: lost async page > write due to I/O error > on 08:00 > May 1 18:55:39 baldrick last message repeated 5 > times > May 1 18:55:39 baldrick kernel: I/O error: dev > 08:00, sector 0 > May 1 18:55:39 baldrick kernel: lost async page > write due to I/O error > on 08:00 > May 1 18:55:39 baldrick last message repeated 3 > times > May 1 18:55:39 baldrick kernel: I/O error: dev > 08:00, sector 0 > May 1 18:55:39 baldrick kernel: lost async page > write due to I/O error > on 08:00 > May 1 18:55:39 baldrick last message repeated 3 > times > May 1 18:55:39 baldrick kernel: unable to read > partition table > May 1 18:55:39 baldrick kernel: Device not ready. > Make sure there is a > disc in the drive. > May 1 18:55:39 baldrick kernel: I/O error: dev > 08:00, sector 0 > May 1 18:55:39 baldrick kernel: Device not ready. > Make sure there is a > disc in the drive. > > > > -- > [email protected] > www.mearsonline.co.uk > > _______________________________________________ > clie-linux mailing list > [email protected] > http://kreucher.net/mailman/listinfo/clie-linux > > Sony Clié and Linux Homepage: > http://kreucher.net/clie/ __________________________________ Do you Yahoo!? The New Yahoo! Search - Faster. Easier. Bingo. http://search.yahoo.com _______________________________________________ clie-linux mailing list [email protected] http://kreucher.net/mailman/listinfo/clie-linux Sony Clié and Linux Homepage: http://kreucher.net/clie/