Problem going back to original boot loader

Hi,

I installed Familiar-GPE 0.8.4 this weekend on an iPaq H5400. Everything
 went well, I installed the bootloader and the rootfs. Familiar boot
fine and every thing was working nicely except for the internal wifi
interface that was not detected.

I found this wiki page
(http://www.handhelds.org/moin/moin.cgi/UpdateWifiH5450) that is saying
that I should upgrade the wifi firmware but that I need to go back to winCE.

I reinstalled winCE using my backup, then I tried the firmware update
with error. So now I think I need the original bootloader to be able to
install firmware update but when I tried to use my backup in
BootBlaster3900-2.6.exe, I got this error:
\My Documents\saved_bootldr.gz is not a valid bootloader image
[ea003fe,43454345,ea000026]

I have no idea what is my problem. After googleling for a while I found
this post that describes the exact same problem that I have but there is
no solution:
http://osdir.com/ml/handhelds.linux.h5400/2003-10/msg00046.html


Any help would be appreciated!

Thanks
Jean-Michel

_______________________________________________
The Familiar Linux Distribution
Familiar mailing list
[email protected]
https://handhelds.org/mailman/listinfo/familiar
irc://irc.freenode.net #familiar