Re: Cannot boot into Bootldr on iPaq h5550
Milan Plzik <[email protected]>
| Newsgroups | gmane.comp.handhelds.linux.familiar |
|---|---|
| Message-ID | <1208901551.6713.1.camel@localhost> |
On Po, 2008-04-21 at 23:09 -0700, TinTTi wrote: > I have problems installing Familiar Linux v0.8.4 on my iPAQ H5550. > I copied BootBlaster and bootldr to the iPAQ and successfully flashed the > new bootldr. Selecting 'Verify' in BootBlaster says 'mach_type set to 203 = > 0xcb' and 'You appear to have a valid OHH Bootloader 2.21.12 in flash. To > access this Bootloader on the serial port, hold the joypad center and > reset'. > > However, if I do that the iPAQ just buzzes and does not reboot. bootldr doesn't know how to control the display, so it basically doesn't change it -- that's why you still see WinCE image after holding joypad down and rebooting. But buzzing indicates that on serial console you should already see bootldr > Rebooting > without holding the joypad center just boots into WinCE. That is correct behavior:) > > TinTin Milan _______________________________________________ The Familiar Linux Distribution Familiar mailing list [email protected] https://handhelds.org/mailman/listinfo/familiar irc://irc.freenode.net #familiar