Re: REf Linksys card...

I had the same problem.  Just create a file under /boot called params,
and put the linuxargs in that.  After I did that it boots everytime with
no problem.

Wayne


On Wed, 2002-02-27 at 10:37, Craig Soucie wrote:
> This may or may not help.  I can use my Linksys card in Familiar, more
> or less (frame and multicast errors but I can still network), using
> their OTB (out of the box) config.  I am still having issues getting
> Intimate to boot w/o resetting the linuxargs each time so I don't
> remember if there were issues with that, however, in RH and Mandrake
> systems I need to download and install the linux-wlan-ng drivers/stuff
> (http://www.linux-wlan.com/linux-wlan/)to get it working (more or less,
> networks fine, shows up in the ifconfig fine, but doesn't show up in the
> iwconfig and don't know if it should).  You might try that if you are
> not getting it to work otherwise, I installed that and it was working
> right away (don't forget to tweek the config files listed in the
> readme).
> If that doesn't work there was something in the Familiar email listings
> (might have been six months ago) about a tweek that was used before to
> make Linksys wireless cards work and that might have some clues.  I'm so
> lazy that the distro version incorporated it before I got around to
> figuring it out so I'm no help there.
> Good Luck.
> Craig
> 
> _______________________________________________
> Full Blown Linux on Handheld Devices.
> Intimate mailing list
> [email protected]
> http://handhelds.org/mailman/listinfo/intimate
>