Re: Garbage output of Collie 2.6 kernel in serial console

Hi,

On Sat, 2007-01-27 at 18:03 +0800, Jason Miu wrote:
> I am trying to start a kernel 2.6 development on my SL5500 but have a 
> problem with my serial console. My 2.6 kernel is compiled from OE and 
> the tmp/work directory shows it has the version 
> "collie-linux/linux-rp-2.6.18-r7". I connected my sharp serial console 
> cable to my host, and fire up the kermit as my terminal. The startup 
> messages looks fine, but become all the garbages finally. Screen shot here:

I think there is some problem with the serial port flow control on
collie. Did you try different flow control options? I have problems with
poodle serial output which uses the same LOCOMO chip although it doesn't
do the serial port setup that collie does.

Regards,

Richard


-------------------------------------------------------------------------
Take Surveys. Earn Cash. Influence the Future of IT
Join SourceForge.net's Techsay panel and you'll get the chance to share your
opinions on IT & business topics through brief surveys - and earn cash
http://www.techsay.com/default.php?page=join.php&p=sourceforge&CID=DEVDEV