Re: Collie MMC SPI Driver alpha2
"Arieh Skliarouk" <[email protected]>
| Newsgroups | gmane.comp.handhelds.openzaurus.devel |
|---|---|
| Message-ID | <[email protected]> |
Hello Thomas, > * Battery LED remains off on power connect. Apparently, the > > battery is actually charged, as the thing is working for an hour > > already with WiFI on. > > > The kernel should not charge the battery. If you have the power cable > connected, the zaurus don't need a battery. I think that kernel needs to turn on the yellow "charging battery" LED on AC power plug-in, and turn off the LED, on AC power disconnection (Like the 2.4kernel did). Today I tried to test an 4GB CF Seagate ST1 harddisk (ripped from an broken iPod). The disk produced the same error messages on 2.6, as on 2.4: <5>pccard: PCMCIA card inserted into slot 0 <5>pcmcia: registering new device pcmcia0.0 <6>Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2 <6>ide: Assuming 50MHz system bus speed for PIO modes; override with idebus=xx <7>Probing IDE interface ide0... ... <5>ide-cs: ide_register() at 0xc4820000 & 0xc482000e, irq 35 failed <7>Probing IDE interface ide0... ... <5>ide-cs: ide_register() at 0xc4820000 & 0xc482000e, irq 35 failed <5>pccard: card ejected from slot 0 May be you have a clue on this?... Apparently the Collie SD drive does not support MMC+ standard, as the kernel did not reported anything in dmesg, when I inserted an MMC+ 128MB card. Am I right? -- Arieh ------------------------------------------------------------------------- This SF.net email is sponsored by DB2 Express Download DB2 Express C - the FREE version of DB2 express and take control of your XML. No limits. Just data. Click to get it now. http://sourceforge.net/powerbar/db2/ _______________________________________________ Openzaurus-devel mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/openzaurus-devel