Re: 1.2.3 freeze in effect

Hello Paul,

Thursday, February 15, 2007, 9:53:47 PM, you wrote:

[]

> When testing for 1829 I was sending files to an old Palm III. I've just
> done some more testing, sending contacts to a phone and a PocketPC
> handheld (from my h3970 this time) and I was able to get it to die after
> about 3 or 4 successful sends each time. This is still with Opie 1.2.1
> though.

  I don't know if this is of any value, but when trying to beam contact
with OE.dev-built OPIE, it locks up even before first successful
transfer. Just - you start it, dialog appears, OPIE menu responds, and
then some time later OPIE hangs. Device is not though, and fully
responsive.

  All this happens with BT enabled too, that's why I said I'm not sure
if it's useful. Another reason is that I'm not sure if that's OPIE
problem or issue with some 3rd party software used by it.

  That's why I asked Dmitry if there're docs on 3rd party requirements
for BT and other subsystems.
  

> Cheers,
> Paul


-- 
Best regards,
 Paul                            mailto:[email protected]

_______________________________________________

http://opie.handhelds.org/cgi-bin/moin.cgi/DeveloperWikiIndex

Opie-devel mailing list
[email protected]
https://handhelds.org/mailman/listinfo/opie-devel