OPIE 0n OMAP 1510 Innovator
"James Selvam" <[email protected]>
| Newsgroups | gmane.comp.handhelds.opie |
|---|---|
| Message-ID | <[email protected]> |
Hi All, Im trying to use OPIE on my OMAP 1510 Innovator board. I have used the root file system image available at familiar.handhelds.org ( opie-image-v0.8.4-rc1-h6300.rootfs.tar.bz2). But the OPIE will not go beyond the initial screen. It asks me to tap to start but does not. Also if I ran the OPIE applications (like calculator or datebook) from debug console it puts up the appln window but does not take the input from touch screen. I then independantly compiled applications like ts_calibrate and ran it. It runs; and gives the right coordinates; showing that the touchscreen interface is all right. Now the only difference I can see is that these applications (ts_calibrate) were statically built (without dynamical linking) whereas OPIE may not. But when I am loading the applications (like calculator) certain messages are thrown out which indicate dynamic linking (the libapplets.so being loaded etc). Is there any configuration that I am missing? Regards, James. PS : The udev has problems due to which certain devices are not created. All devices have been manually created and the corresponding /dev/input/input0/event0 is added & working. _______________________________________________ Open Source User Interface and Apps built on Qt Embedded Opie mailing list [email protected] https://handhelds.org/mailman/listinfo/opie