How to configure touchscreen
Detlef Vollmann <[email protected]>
| Newsgroups | gmane.comp.handhelds.opie |
|---|---|
| Organization | vollmann engineering gmbh |
| Message-ID | <[email protected]> |
Hello, after installing Opie on my own device (PXA270 with QVGA touchscreen) the touchscreen isn't used. The welcome screen comes fine, but tapping isn't detected, and strace shows that tslib is loaded, but the touchscreen device is never opened. The Qt embedded underneath Opie is configured to use tslib and /dev/touchscreen/ucb1x00. The touchscreen itself works fine, ts_calibrate runs with no problem. So I assume there must be some way to tell Opie what pointer device to use, but I didn't find how to tell that. Any help appreciated. Detlef -- Detlef Vollmann vollmann engineering gmbh Linux and C++ for Embedded Systems http://www.vollmann.ch/ Linux for PXA270 Colibri module: http://www.vollmann.ch/en/colibri/ _______________________________________________ Open Source User Interface and Apps built on Qt Embedded Opie mailing list [email protected] https://handhelds.org/mailman/listinfo/opie