Opie on a iPaQ 3850 - Part 2 Remote

Hello,

now the 2nd part - well, by now I have accepted that it is problematic to sync 
data between Opie and KDE PIM. Therefore I wanted to use my iPaQ as remote 
control.

After reading the help instructions and following them, I am able to start the 
application without the message: couldn't connect to socket. 
Good I thought - no error message! Even the lircd.conf I found is exactly for 
the remote conrol(s) I want to replace. In detail, I have merged two remote 
descriptions in the file lircd.conf. The mapping was simple and I thought 
that is it. 

Of course, my TV does not think so...

How can I check that the iPaQ is really sending the correct signal?
Any other ideas what I can do?

Regards

Martin
_______________________________________________
Open Source User Interface and Apps built on Qt Embedded
Opie mailing list
[email protected]
https://handhelds.org/mailman/listinfo/opie