Re: Calibration Broken

I just installed Familiar with Opie 1.2 on an iPaq 3650.  The
installation and post-install setup went fine, but when I reached the
desktop the entire area of the touchscreen seemed to be mapped to the
bottom left corner of the screen.  I managed to open DrawPad and found
that if I tap the top right corner, the click occurrs about 1/2 inch
up from the bottom, and 1/4 inch from the left of the screen.

The strangest part, however, is that the calibration was fine on all
the setup screens that appear after the calibration on first boot.
(Calibration also worked fine in GPE.)

Anyone know of a possible cause and/or solution?

--
   Thanks!
    ~Darin Wick

"How do you make God laugh?  Make a plan."  ~Billy Collins
_______________________________________________
Open Source User Interface and Apps built on Qt Embedded
Opie mailing list
[email protected]
https://handhelds.org/mailman/listinfo/opie