Re: Re: Calibration Broken

On Thursday 04 of December 2008 21:22:02 Paul Eggleton wrote:
> On Thursday 04 December 2008, Darin Wick wrote:
> > I just installed Familiar with Opie 1.2 on an iPaq 3650.  The
> > installation and post-install setup went fine, but when I reached the
> > desktop the entire area of the touchscreen seemed to be mapped to the
> > bottom left corner of the screen.  I managed to open DrawPad and found
> > that if I tap the top right corner, the click occurrs about 1/2 inch
> > up from the bottom, and 1/4 inch from the left of the screen.
>
> Occasionally the touchscreen calibration just seems to go nuts. It doesn't
> seem to happen often, but it occurs on all sorts of devices. You can get to
> the recalibrate function by going to the launcher (iTask or equivalent
> button on the 3600), pressing the iTask button again several times to get
> to the settings tab, and then using the directional pad to select the
> Recalibrate icon. Alternatively restarting seems to do the trick as well.
>
> I'd love to sort this out permanently but am not really sure where to
> begin, considering it is difficult to reproduce the problem consistently.
>
> Cheers,
> Paul

what about replacing it with ts_calibrate? it does the trick as well ...

Marek
_______________________________________________
Open Source User Interface and Apps built on Qt Embedded
Opie mailing list
[email protected]
https://handhelds.org/mailman/listinfo/opie