Re: xilinx parallel III usable with simpad?

Thank you, Jurgen & Ralf for your reply
What I can see from the ad, there are 12 output pins on seperate wires. As
it is billled as an "universal" jtag programmer, and I can change the
sequence of the pin connections, there is a good chance it'll work
I'll let you know.
best regards
glenn
----- Original Message ----- 
From: "Juergen Messerer" <[email protected]>
To: "Glenn" <[email protected]>
Cc: <[email protected]>
Sent: Monday, April 05, 2004 9:48 AM
Subject: Re: [Simpad-general] xilinx parallel III usable with simpad?


> You have to test it. Normally it should if the pins are the same like
> the one on the board.
> Otherwise there some good free tools availbale at sourceforge. one is
> openwince
>
> Best regards
>
> Juergen
>
>
> Glenn wrote:
>
> >Hi all,
> >
> >Can I use the xilinx parallell III kit directly with simpad & jtag? I
> >haven't found the time to make my own ( I wouldn't trust it either :) and
my
> >simpad is but a fragile coaster in the meantime.
> >
> >betst regards
> >glenn
> >
> >
> >-------------------------------------------------------
> >This SF.Net email is sponsored by: IBM Linux Tutorials
> >Free Linux tutorial presented by Daniel Robbins, President and CEO of
> >GenToo technologies. Learn everything from fundamentals to system
> >administration.http://ads.osdn.com/?ad_id=1470&alloc_id=3638&op=click
> >_______________________________________________
> >Simpad-general mailing list
> >[email protected]
> >https://lists.sourceforge.net/lists/listinfo/simpad-general
> >
> >
> >
>
>
>


-------------------------------------------------------
This SF.Net email is sponsored by: IBM Linux Tutorials
Free Linux tutorial presented by Daniel Robbins, President and CEO of
GenToo technologies. Learn everything from fundamentals to system
administration.http://ads.osdn.com/?ad_id=1470&alloc_id=3638&op=click