Re: xilinx parallel III usable with simpad?

You have to test it. Normally it should if the pins are the same like 
the one on the board.
Otherwise there some good free tools availbale at sourceforge. one is 
openwince

Best regards

Juergen


Glenn wrote:

>Hi all,
>
>Can I use the xilinx parallell III kit directly with simpad & jtag? I
>haven't found the time to make my own ( I wouldn't trust it either :) and my
>simpad is but a fragile coaster in the meantime.
>
>betst regards
>glenn
>
>
>-------------------------------------------------------
>This SF.Net email is sponsored by: IBM Linux Tutorials
>Free Linux tutorial presented by Daniel Robbins, President and CEO of
>GenToo technologies. Learn everything from fundamentals to system
>administration.http://ads.osdn.com/?ad_id=1470&alloc_id=3638&op=click
>_______________________________________________
>Simpad-general mailing list
>[email protected]
>https://lists.sourceforge.net/lists/listinfo/simpad-general
>
>  
>




-------------------------------------------------------
This SF.Net email is sponsored by: IBM Linux Tutorials
Free Linux tutorial presented by Daniel Robbins, President and CEO of
GenToo technologies. Learn everything from fundamentals to system
administration.http://ads.osdn.com/?ad_id=1470&alloc_id=3638&op=click