RE: tightening screws on the TX

The Tx doesn't have a slider right?

Then'd I'd guess it would be fine.  However, take a tip from my mother, when
I was a kid with glasses that had similar problems, get a clear finish nail
polish and apply it to pesky screws, update as needed.  The added 'glue' of
the nail polish is nearly invisible and should hold a screw in place, or at
least give you a visual evidence when its loosening (the polish would flake
off).

> -----Original Message-----
> From: [email protected] 
> [mailto:[email protected]] On Behalf Of Michael Williams
> Sent: Tuesday, August 15, 2006 9:23 PM
> To: [email protected]
> Subject: [Tungsten_T] tightening screws on the TX
> 
> used to have a T3, and would have to tighten the side screws 
> periodically, or risk losing them.
> 
> now have a TX. does the TX have the same problem? i haven't 
> seen it so far (all screws are holding tight).
> 
> --
> michael
> 
> 
> 
> Group Reminders:
> 
> * Members who spam the group may be banned without warning.
> 
> * Members who are hard bouncing may be unsubscribed without warning
>   (they may rejoin the group when their mailbox problems have 
> been addressed). 
> Yahoo! Groups Links
> 
> 
> 
>  
> 
>