RE: tightening screws on the TX

No, T3 does not have slider. Only palm tungsten t, t2 and T3 have a slider.


--
Best regards

Pavel Bures


-----Original Message-----

From:  "David Wade Hagar AKA Cyclops" <[email protected]>
Subj:  RE: [Tungsten_T] tightening screws on the TX
Date:  Wed Aug 16, 2006 7:14 am
Size:  1K
To:  <[email protected]>

                 The Tx doesn't have a slider right?
 
 Then'd I'd guess it would be fine.  However, take a tip from my mother, when
 I was a kid with glasses that had similar problems, get a clear finish nail
 polish and apply it to pesky screws, update as needed.  The added 'glue' of
 the nail polish is nearly invisible and should hold a screw in place, or at
 least give you a visual evidence when its loosening (the polish would flake
 off).
 
  -----Original Message-----
  From: [email protected] 
  [mailto:[email protected]] On Behalf Of Michael Williams
  Sent: Tuesday, August 15, 2006 9:23 PM
  To: [email protected]
  Subject: [Tungsten_T] tightening screws on the TX
  
  used to have a T3, and would have to tighten the side screws 
   --- message truncated --- 



Group Reminders:

* Members who spam the group may be banned without warning.

* Members who are hard bouncing may be unsubscribed without warning
  (they may rejoin the group when their mailbox problems have been addressed). 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/Tungsten_T/

<*> To unsubscribe from this group, send an email to:
    [email protected]

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/