Re: Zaurus SL-5600 and Networking

On Sunday 23 November 2003 03:41 am, Tim Sawchuck wrote:
> On Sun, 23 Nov 2003 13:40:12 -0500
>
> "Ted A Richart" <[email protected]> scribed on electronic 
parchment:
> > I am new to the "OpenPDA" community, so please bear with me.
> >
> > I am the proud owner of the above mentioned Zaurus, but I can't
> > seem to figure out how to get this puppy on the network. I have a
> > New Media LiveWire 10BT Ethernet CF card (NE2000 as I recall).
> >

Tim, (& Tedro),

> Here are a few places to start.  No particular order, but first two
> are likely most helpful.  Also keep in mind that most current
> distors will use usb0 and not usbd0 as you will still see in some
> guides.

Just so no one gets confused...  usb0 and usbd0 do not apply in the 
situation where Tedro is using a CF Ethernet card.  More likely the 
interface name (if the device was recognized) will be "eth0".

>
> http://www.zauruszone.farplanet.net/wiki/index.php?NetworkingHowTo
>

This link was the most on-point:
http://www.zauruszone.farplanet.net/wiki/index.php?EthernetCardSupport

> <snip>

Dave