Re: Compatibility of GCC with ATMEGA128RFA1

I've been compiling for it with WinAVR & GCC on Linux for years, so I'd say
it works ok provided you've built your tools correctly (or use precompiled).

  -Colin

-----Original Message-----
From: [email protected]
[mailto:[email protected]] On Behalf Of
Weddington, Eric
Sent: January-13-13 12:44 AM
To: Jason; [email protected]
Subject: Re: [avr-gcc-list] Compatibility of GCC with ATMEGA128RFA1

Hi Jason,

Yes, we're familiar with the ATmega128RFA1. IIRC, patches are available.
Have you checked to see if it's supported in the Atmel Toolchain?

> -----Original Message-----
> From: [email protected]
> [mailto:[email protected]] On 
> Behalf Of Jason
> Sent: Saturday, January 12, 2013 9:11 PM
> To: [email protected]
> Subject: [avr-gcc-list] Compatibility of GCC with ATMEGA128RFA1
> 
> Hi,
> 
> I am interested in using the ATmega128rfa1 with the AVR-GCC toolchain.
> Is this chip supported?
> 
> ATmega128rfa1 Datasheet: http://www.atmel.com/Images/doc8266.pdf
> 
> Some background:
> 
> The ATmega128RFA1 is a low-power CMOS 8-bit microcontroller based on 
> the AVR enhanced RISC architecture combined with a high data rate 
> transceiver for the 2.4 GHz ISM band. It is derived from the 
> ATmega1281 microcontroller and the
> AT86RF231 radio
> transceiver.
> 
> Regards,
> Jason
> 
> E: [email protected]
> 
> _______________________________________________
> AVR-GCC-list mailing list
> [email protected]
> https://lists.nongnu.org/mailman/listinfo/avr-gcc-list

_______________________________________________
AVR-GCC-list mailing list
[email protected]
https://lists.nongnu.org/mailman/listinfo/avr-gcc-list