Re: Compatibility of GCC with ATMEGA128RFA1
Mr Jason Edwards <[email protected]>
| Newsgroups | gmane.comp.hardware.avr.gcc |
|---|---|
| Message-ID | <[email protected]> |
Thanks. I'll restart and give another shot. Regards, Jason Edwards. On 16/01/2013, at 6:44 AM, "Colin O'Flynn" <[email protected]> wrote: > I've been compiling for it with WinAVR & GCC on Linux for years, so I'd say > it works ok provided you've built your tools correctly (or use precompiled). > > -Colin > > -----Original Message----- > From: [email protected] > [mailto:[email protected]] On Behalf Of > Weddington, Eric > Sent: January-13-13 12:44 AM > To: Jason; [email protected] > Subject: Re: [avr-gcc-list] Compatibility of GCC with ATMEGA128RFA1 > > Hi Jason, > > Yes, we're familiar with the ATmega128RFA1. IIRC, patches are available. > Have you checked to see if it's supported in the Atmel Toolchain? > >> -----Original Message----- >> From: [email protected] >> [mailto:[email protected]] On >> Behalf Of Jason >> Sent: Saturday, January 12, 2013 9:11 PM >> To: [email protected] >> Subject: [avr-gcc-list] Compatibility of GCC with ATMEGA128RFA1 >> >> Hi, >> >> I am interested in using the ATmega128rfa1 with the AVR-GCC toolchain. >> Is this chip supported? >> >> ATmega128rfa1 Datasheet: http://www.atmel.com/Images/doc8266.pdf >> >> Some background: >> >> The ATmega128RFA1 is a low-power CMOS 8-bit microcontroller based on >> the AVR enhanced RISC architecture combined with a high data rate >> transceiver for the 2.4 GHz ISM band. It is derived from the >> ATmega1281 microcontroller and the >> AT86RF231 radio >> transceiver. >> >> Regards, >> Jason >> >> E: [email protected] >> >> _______________________________________________ >> AVR-GCC-list mailing list >> [email protected] >> https://lists.nongnu.org/mailman/listinfo/avr-gcc-list > > _______________________________________________ > AVR-GCC-list mailing list > [email protected] > https://lists.nongnu.org/mailman/listinfo/avr-gcc-list >