Re: 2313 output pin problem

-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

Hi all,

At the suggestion of Anderas Strodl, I tested the other portb pins with
an LED, and found that all pins work *except* for PB7 (SCK) and PB5
(MOSI). Those happen to be the input pins used for serial programming.
But why would they be stuck in input mode? The programmer isn't hooked
up, and I'm not holding -RST low, so it can't still be in programming
mode...

- --Rob



-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.2.3 (MingW32)
Comment: Using GnuPG with Mozilla - http://enigmail.mozdev.org

iD8DBQE/5z+i3n80I35hhEsRAouaAKCX/o/VCELKN68jPg+eY20YaOfiSQCfdesI
cOFK0XMEaT+RTG2L4xFf4Is=
=OVNB
-----END PGP SIGNATURE-----