Re: AT90S8515-JC

At 08:03 11/05/2003 -0400, Brian Dean wrote:
>On Fri, May 09, 2003 at 07:09:00PM +1200, Jason Kyle wrote:
>
> > I plan to make an ATmega64/128 adapter board that connects to the PLCC
> > socket holes, that way the board can stay the same and I don't end up with
> > a pile of unusable PCBs :)
>
>Sounds great!  You can also probably sell your adapter board to lots
>of folks who will be in the same position with their 8515 projects so
>this may work out rather well for you :-)

What would be really useful is a board that actually plugs into a PLCC 
socket, but alas there are very few options for PLCC plugs and most are 
seriously high priced due to their low volumes.  Not too hard to remove a 
PLCC socket, now where's that solder sucker......

Cheers,

Jason


>Cheers,
>-Brian
>--
>Brian Dean, [email protected]
>BDMICRO - Maker of the MAVRIC ATmega128 Dev Board
>http://www.bdmicro.com/