Re: CANstress configuration
Heinz-Jürgen Oertel <[email protected]>
| Newsgroups | gmane.comp.hardware.bus.can |
|---|---|
| Organization | privat |
| Message-ID | <[email protected]> |
Am Freitag 26 Juli 2013, 11:19:19 schrieben Sie:
> Hi all,
>
> How to create Error passive error in CAN bus using CANstressDR.?
> Can anyone share me the .cst file or guide me how to configure CANstressDR?
>
> I need only Error passive fault not Busoff.
>
>
> Thanks & Regards
> --------------------
> G.Raja
To get into error passive is very simple even without devices like CANstress.
Let the CAN controller send a frame and remove all other nodes from the CAN bus.
If the transmitting not does not get any acknowledge from other nodes,
it will increase the transmit error counter until it reaches the error passive state.
--
mit freundlichen Grüßen
Heinz-Jürgen Oertel
signature.asc
(application/pgp-signature, 490 B)
-----BEGIN PGP SIGNATURE----- Version: GnuPG v2.0.19 (GNU/Linux) iQEcBAABAgAGBQJR8hdpAAoJENViPQy9fcm7e90H/1NBKnl1zFMuoFVe3AS/SpGY deQIWwuznn0vm6rVb5T9e+DLZX84bQhf4uE92whfmN3s7W6cM/B0sjUt4Oe9+yZ0 xQnAgBcGVCwWD0fCert6SHjBHUmh0D4icwpHHFzKJwxzhClTwgpXn110Itd3BsC/ tpFfOkgR1yeuUJ/RzbjHclQwxXZfKdANvArKQBDc3ThxYgRL6aI84D+LN15EBNtC fFYowJJWBggAMGl610iShX5BsxmuQFDVIlCsXfZzGdGrBI5ABZHaseSeW/kU6qW3 6UIi11t+fbfGfNMHYiFUFy1l/PPhd+AjtOAP//jUbPkYce6VHGuEK0g46pzP080= =Y9tw -----END PGP SIGNATURE-----