Re: CANstress configuration
canlist_NOT via NavTool <[email protected]>
| Newsgroups | gmane.comp.hardware.bus.can |
|---|---|
| Message-ID | <[email protected]> |
Am Freitag 26 Juli 2013, 11:19:19 schrieben To get into error passive is very simple even without devices like CANstress. Let the CAN controller send a frame and remove all other nodes from the CAN bus. If the transmitting not does not get any acknowledge from other nodes, it will increase the transmit error counter until it reaches the error passive state. -- mit freundlichen Grüßen Heinz-Jürgen Oertel
signature.asc
(text/plain, 491 B)
-----BEGIN PGP SIGNATURE----- Version: GnuPG v2.0.19 (GNU/Linux) iQEcBAABAgAGBQJR8hdpAAoJENViPQy9fcm7e90H/1NBKnl1zFMuoFVe3AS/SpGY deQIWwuznn0vm6rVb5T9e+DLZX84bQhf4uE92whfmN3s7W6cM/B0sjUt4Oe9+yZ0 xQnAgBcGVCwWD0fCert6SHjBHUmh0D4icwpHHFzKJwxzhClTwgpXn110Itd3BsC/ tpFfOkgR1yeuUJ/RzbjHclQwxXZfKdANvArKQBDc3ThxYgRL6aI84D+LN15EBNtC fFYowJJWBggAMGl610iShX5BsxmuQFDVIlCsXfZzGdGrBI5ABZHaseSeW/kU6qW3 6UIi11t+fbfGfNMHYiFUFy1l/PPhd+AjtOAP//jUbPkYce6VHGuEK0g46pzP080= =Y9tw -----END PGP SIGNATURE-----