Re: I connect my device to a truck's can port (J1939) , the truck present an error .

Hi
My rx/tx error counter is in the GSR (globle status) register. They are initialized to 0/127 .  If I initialize them to more than 128 and I make sure they always bigger than 128 (for example set them to 150/150 in rx/tx routines), will my device works always at a error passive mode? So it won't corrupt the bus . 

     On Wednesday, January 21, 2015 7:55 PM, Anry A. Kischka <[email protected]> wrote:
   

 Thank you! I understand that's embedded OS, but to topic starter i told
about physical CAN driver.

I think that no matter what OS used in MCU for connecting and working with
CANbus line...

Heinz-Jürgen Oertel пишет:
//
// Am Mittwoch, 21. Januar 2015, 12:55:41 schrieb Anry A. Kischka:
//> What is ECOS system!? I'm not understood you. Can you give me link to
//> datasheet?
//
//
// https://ru.wikipedia.org/wiki/ECos
// https://en.wikipedia.org/wiki/ECos
//
//
// --
// mit freundlichen Grüßen
//        Heinz-Jürgen Oertel
//     emtas GmbH
// --
// Archives and useful links: http://groups.yahoo.com/group/CANbus
// Subscribe and unsubscribe at www.vector.com/canlist/
// Report any problems to <[email protected]>
//


-- 
With best regards, Anry.

--
Archives and useful links: http://groups.yahoo.com/group/CANbus
Subscribe and unsubscribe at www.vector.com/canlist/
Report any problems to <[email protected]>