Re: I connect my device to a truck's can port (J1939) , the truck present an error .

Hi,
Can you answer me step-by-step, please.
So...
1. What truck model you try to connect?
2. What faults (SPN, FMI) you get when connect your device (in normal
mode)to truck and what in unit (ECU, EBS, Gear and etc)?
3. And what physical CAN driver you used in device!?
thanks!

c yl пишет:
// Hi
// My rx/tx error counter is in the GSR (globle status) register. They are
// initialized to 0/127 .  If I initialize them to more than 128 and I make
// sure they always bigger than 128 (for example set them to 150/150 in rx/tx
// routines), will my device works always at a error passive mode? So it
// won't corrupt the bus .
//
//      On Wednesday, January 21, 2015 7:55 PM, Anry A. Kischka
// <[email protected]> wrote:
//
//
//  Thank you! I understand that's embedded OS, but to topic starter i told
// about physical CAN driver.
//
// I think that no matter what OS used in MCU for connecting and working with
// CANbus line...
//
// Heinz-Jürgen Oertel пишет:
// //
// // Am Mittwoch, 21. Januar 2015, 12:55:41 schrieb Anry A. Kischka:
// //> What is ECOS system!? I'm not understood you. Can you give me link to
// //> datasheet?
// //
// //
// // https://ru.wikipedia.org/wiki/ECos
// // https://en.wikipedia.org/wiki/ECos
// //
// //
// // --
// // mit freundlichen Grüßen
// //        Heinz-Jürgen Oertel
// //     emtas GmbH
// // --
// // Archives and useful links: http://groups.yahoo.com/group/CANbus
// // Subscribe and unsubscribe at www.vector.com/canlist/
// // Report any problems to <[email protected]>
// //
//
//
// --
// With best regards, Anry.
//
// --
// Archives and useful links: http://groups.yahoo.com/group/CANbus
// Subscribe and unsubscribe at www.vector.com/canlist/
// Report any problems to <[email protected]>
//
//
//


-- 
With best regards, Anry.

--
Archives and useful links: http://groups.yahoo.com/group/CANbus
Subscribe and unsubscribe at www.vector.com/canlist/
Report any problems to <[email protected]>