Re: CAN bus real-time sender and precise timestamp receiver tool

Am Freitag, 11. September 2015, 08:27:45 schrieb Stephen Glow:
> Hi David;
> 
> My company makes a single channel USB CAN interface which timestamps 
> receive messages with 1us resolution, and can optionally timestamp 
> transmitted messages with the time they actually were sent out on the 
> bus with 1us resolution.  That would allow you to use a single channel 
> for this application.  If the USB latency is a major concern then our 
> PCIe based cards have the same timestamping capabilities.
> http://embeddedintelligence.com/
> 
> In my experience, you shouldn't have any problem transmitting from the 
> PC with millisecond resolution.  Linux will likely give you the best 
> results, but even under Windows it should be achievable.
> 
> I apologize for posting what may be deemed a commercial message on this 
> list, but in this case it seemed relevant to the question posed.
> 
> Please feel free to contact me with any questions.
> 
> Steve Glow
> President
> Embedded Intelligence, Inc
> 508-380-0676

Steve,
your interfaces are not listed here: 
  http://www.can-wiki.info/doku.php?id=can_interfaces:main

Regards
  Heinz
  emtas GmbH
--
Archives and useful links: http://groups.yahoo.com/group/CANbus
Subscribe and unsubscribe at www.vector.com/canlist/
Report any problems to <[email protected]>