Proper blaster config in this file?

Hello,

I have an MCE remote working perfectly ( first part of the config )

The remote is from my STB box, and I need to transmit those same signals 
to my STB to change channels.

So in the config below, I simply duplicated the config and renamed it 
"blaster"

However, it does not seem to work!


Any advice?  Would the send and receive config be the same with the codes?


Thanks


Mark

Please make this file available to others
# by sending it to <[email protected]>
#
# this config file was automatically generated
# using lirc-0.9.0(default) on Mon Mar 20 14:57:23 2017
#
# contributed by
#
# brand:                       own_remote.conf.conf
# model no. of remote control:
# devices being controlled by this remote:
#

begin remote

   name  own_remote.conf
   bits            8
   flags RCMM|CONST_LENGTH
   eps            18
   aeps          100

   header        417   278
   three         167   778
   two           167   611
   one           167   444
   zero          167   278
   ptrail        167
   pre_data_bits   24
   pre_data       0x248026
   gap          99817
   min_repeat 1
   suppress_repeat 2
   toggle_bit_mask 0x8000

begin codes
           KEY_1                    0x01
           KEY_2                    0x02
           KEY_3                    0x03
           KEY_4                    0x04
           KEY_5                    0x05
           KEY_6                    0x06
           KEY_7                    0x07
           KEY_8                    0x08
           KEY_9                    0x09
           KEY_0                    0x00
       KEY_POWER                0x0C
           KEY_REWIND               0x29
           KEY_STOP                 0x31
           KEY_FASTFORWARD          0x28
           KEY_PAUSE                0x2C
           KEY_OK                   0x5C
           KEY_VOLUMEUP             0x0C
           KEY_CHANNELUP            0x20
           KEY_CHANNELDOWN          0x21
       end codes

end remote

begin remote

   name  blaster
   bits            8
   flags RCMM|CONST_LENGTH
   eps            18
   aeps          100

   header        417   278
   three         167   778
   two           167   611
   one           167   444
   zero          167   278
   ptrail        167
   pre_data_bits   24
   pre_data       0x248026
   gap          99817
   min_repeat 1
   suppress_repeat 2
   toggle_bit_mask 0x8000

begin codes
           KEY_1                    0x01
           KEY_2                    0x02
           KEY_3                    0x03
           KEY_4                    0x04
           KEY_5                    0x05
           KEY_6                    0x06
           KEY_7                    0x07
           KEY_8                    0x08
           KEY_9                    0x09
           KEY_0                    0x00
           KEY_POWER                0x0C
           KEY_REWIND               0x29
           KEY_STOP                 0x31
           KEY_FASTFORWARD          0x28
           KEY_PAUSE                0x2C
           KEY_OK                   0x5C
           KEY_VOLUMEUP             0x0C
           KEY_CHANNELUP            0x20
           KEY_CHANNELDOWN          0x21
       end codes

end remote


------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot