Re: Proper blaster config in this file?

On 03/22/17 15:18, Mark wrote:
> Hello,
>
> I have an MCE remote working perfectly ( first part of the config )
>
> The remote is from my STB box, and I need to transmit those same signals
> to my STB to change channels.
>
> So in the config below, I simply duplicated the config and renamed it
> "blaster"
>
> However, it does not seem to work!
>
>
> Any advice?  Would the send and receive config be the same with the codes?
>
>...

> begin remote
>
>    name  own_remote.conf
>    bits            8
>    flags RCMM|CONST_LENGTH
>    eps            18
>    aeps          100
>
>    header        417   278
>    three         167   778
>    two           167   611
>    one           167   444
>    zero          167   278

Yes, I can tell you. The signals are RCMM or Nokia32. This does not 
decode one bit at a time on one of two bursts (ZERO and ONE), but 
decodes TWO bits at one of four bursts (ZERO, ONE, TWO, THREE). IIRC, 
Lirc can handle this on reading, but it was never implemented for sending.

Other than this, the files are fine, and import without problems in 
IrScrutinizer.

Greetz,

Bengt

------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot