Re: Proper blaster config in this file?
Bengt Martensson <[email protected]>
| Newsgroups | gmane.comp.hardware.lirc |
|---|---|
| Message-ID | <[email protected]> |
On 03/22/17 17:45, John Adams wrote: > On Wed, 22 Mar 2017 15:42:31 +0100 > Bengt Martensson <[email protected]> wrote: > >> >> Yes, I can tell you. The signals are RCMM or Nokia32. This does not >> decode one bit at a time on one of two bursts (ZERO and ONE), but >> decodes TWO bits at one of four bursts (ZERO, ONE, TWO, THREE). IIRC, >> Lirc can handle this on reading, but it was never implemented for >> sending. >> >> Other than this, the files are fine, and import without problems in >> IrScrutinizer. >> >> Greetz, >> >> Bengt > > I have been using RCMM sending with lirc for the last couple of years. > It works perfectly for me (after I blocked the nearby mirror > reflection). Hmm, man lircd.conf(5) sez: RCMM The remote uses the RC-MM protocol (transmitting not supported). so at least one is not "telling the truth". We should clarify. Greetz, Bengt ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot